CC-TAIX11 51308365-175 Analog Input Module | Honeywell

The Honeywell CC-TAIX11 51308365-175, also cataloged as the CC-TAIX11 Analog Input Module, operates as a dedicated hardware component for multi-channel analog signal acquisition and process variable digitization within Honeywell TotalPlant Solution (TPS) platforms.

Hardware Specifications

4-20 mA HART Loop Protocol & Channel-to-Channel Isolation

The CC-TAIX11 module captures voltage, current, and thermocouple process signals across redundant channel pathways. Operating on standard 4-20 mA current loop interfaces and voltage spans, the internal circuitry integrates channel-to-channel isolation barriers that eliminate ground loop potential differences between field transmitters and central control buses. Galvanic isolation buffers filter electrical noise interference, maintaining signal fidelity across high-accuracy analog digital conversion stages.

Frequently Asked Questions

Q: Does the CC-TAIX11 support hot-swapping during active operation?

A: Yes, the CC-TAIX11 supports online hot-swapping, enabling replacement of a faulty module without removing backplane power or disturbing continuous system control execution.

Q: How does the redundant configuration function on the CC-TAIX11?

A: The module incorporates redundant input channels that run parallel processing loops, allowing immediate failover execution if a signal path or hardware failure is detected.

Q: What power input voltage is required for the CC-TAIX11?

A: The module operates from a standard 24 VDC system power rail provided through the backplane assembly.

Field Installation Guidelines

1. Align the CC-TAIX11 module with the designated backplane card guides and insert firmly until the edge connector fully seats.
2. Route 4-20 mA current loop and thermocouple field cables through designated wire ducts, maintaining physical separation from high-voltage AC lines.
3. Connect field wiring cable shields to the cabinet grounding bar at a single point to prevent ground loop currents from introducing measurement offset errors.
4. Verify that the 24 VDC power supply voltage remains within operational limits prior to energizing the analog channels.