GE Fanuc DS200SDCCG1AGD DS215SDCCG1AZZ01B I/O Module

DS200SDCCG1AGD – Drive Control Card

Technical Specifications

About the DS200SDCCG1AGD

The DS200SDCCG1AGD Drive Control Board is a key controller designed for the Mark V series of General Electric’s Speedtronic turbine control systems. Although part of a legacy series that has been discontinued, the Mark V series remains crucial for managing gas, steam, and wind turbines.

This version, DS200SDCCG1AGD, is an enhanced revision of the original DS200SDCCG1 Drive Control Board, incorporating three significant updates.

Hardware Features and Specifications

• Microprocessors: Contains three microprocessors—Drive Control Processor, Motor Control Processor, and Co-motor Processor

• Memory: Equipped with shared RAM accessible by multiple processors simultaneously

• LED Diagnostics: Ten LEDs display fault codes for troubleshooting. When no faults are present, LEDs light up in a sequential pattern (two at a time, left to right)

• Safety Note: Due to high voltage inside the board cabinet, never touch components or allow objects to fall inside while powered. Always close the cabinet door after inspection

• Expandable: Supports auxiliary daughterboards for enhanced functionality, including:

• DS215SLCC / 531X306LCC: LAN Communications Card

• 531X309SPC: Signal Processor Card

• DS200SPCB: Multibridge Signal Processor Card

Setup and Configuration

Upon installation, configuration parameters must be set to define how the board controls the drive. Software tools are available for parameter editing on laptops, enabling batch configuration downloads to multiple units.

For comprehensive setup instructions and diagnostic details, refer to the GEI-100029 Drive Control Card Manual.

Frequently Asked Questions (FAQ)

Q: What are the three main microprocessors on the DS200SDCCG1AGD?
A: The three microprocessors are:

• Drive Control Processor

• Motor Control Processor

• Co-motor Processor

Q: How many card connections does the DS200SDCCG1AGD have?
A: There are eight card connections, including 1PL, 7PL, and 11PL. For example, the 7PL connection serves as an I/O link between the Signal Processor or Multibridge Signal Processor Cards and the SDCC board.

Refer to page 2 of the GEI-100019C Instruction Manual for detailed functions of all connections.