GE Fanuc IC698CPE010-CC CPU Module Most Favorable

GE Fanuc IC698CPE010 Central Processing Unit (CPU)

RX7i Series | High-Performance Real-Time Control

Product Overview

The GE Fanuc IC698CPE010 is a high-speed Central Processing Unit (CPU) designed for the RX7i Series of programmable automation controllers. It enables real-time control of industrial machinery and process systems, communicating through a VME64 backplane mounted within the RX7i rack.

Key Features

• 300 MHz Intel Celeron Processor

• Real-time floating-point calculations

• Boolean function execution time: 0.33 ms per coil

• 3 Embedded Serial Ports

• 2 Embedded Ethernet Ports

• Bit-in-word reference support

• Symbolic variable support

• Test Edit mode for programming

• Remote data monitoring via web browser

Memory Specifications

• RAM Memory: 10 MB (for logic and data)

• Non-Volatile Flash Memory (NVRAM): 10 MB

• CMOS Battery-Backed Memory

• Firmware stored in Flash (Upgradeable without disassembly or EPROM replacement)

Communication Interfaces

• Ethernet Ports: Support web-based monitoring and Proficy configuration

• Serial Ports (RS-232, RS-485): Support SNP, Modbus RTU Slave, and Serial I/O

• Protocols: SNP, Modbus RTU

• Ethernet Requirements: Cat5 cable and valid IP addressing

Operation & Configuration

There are two methods to operate the IC698CPE010:

1. Three-Position Run/Stop Switch

2. Software Control via Serial or Ethernet Connection

• Software: Proficy Machine Edition PLC-Logic Developer

• Security: Configuration data protected with password access

Installation Guidelines

1. Power off the rack before installation

2. Record the MAC address of the CPU

3. Mount the CPU securely in slot 1 (dedicated CPU slot)

4. Properly ground the device

5. Connect Ethernet and serial ports

6. Re-enable rack power

7. Attach the CMOS battery

8. Start programming via Proficy software

Always refer to the product manual for detailed installation and safety procedures.

Technical Specifications